TM 5-5420-226-20-3
BRAKE CONTROL HOUSING REPAIR (Sheet 3 of 14)
4.
Using pliers, remove cotter pin (C).
Throw cotter pin away.
Remove pin (D) by pulling out. Remove
5.
push rod (E).
6.
Using pliers, pull pin (F) from housing
clevis (G).
7.
Using pliers, remove cotter pin (H). Throw
cotter pin away.
8.
Using two 9/16 inch wrenches, remove
two nuts (J) by removing lower nut first
while holding upper one.
Move lever assembly (K) clear of control
9.
assembly and remove two washers (L)
and spring (M).
10.
Using retaining ring pliers, remove snap
ring (N).
Slide lever (P) off shaft (Q) and remove
11.
lever (P) and lever assembly (K) with
attached parts from control housing.
Go on to Sheet 4
13-66