TM 5-5420-226-20-3
BRAKE RIGHT HAND SLAVE CYLINDER AND TUBE ASSEMBLY REPLACEMENT (Sheet 4 of 6)
INSTALLATION:
1.
Insert new packing (A) in groove of
slave cylinder (B).
2.
Position and slide slave cylinder (B)
down over housing assembly push rod.
Wiggle it back and forth while pushing
down. Push slave cylinder forward when
on housing assembly, then pull back
to make sure catch engages in housing
assembly.
3.
Tighten mounting nut to stud, finger
tight.
4.
Using 9/16 inch socket, tighten mounting
nut.
5.
Using 9/16 inch socket, remove screw
(C) and lockwasher (D) from adjusting
screw lock plate.
6.
Position and aline adjusting screw lock
-
plate and bracket (E). Insert screw
(C) and lockwasher (D) finger tight.
7.
Using 9/16 inch socket, tighten screw
(c).
Go on to Sheet 5
TA169186