TM 5-5420-226-20-3
PARKING BRAKE CONTROL ASSEMBLY AND LINKAGE REPLACEMENT (Sheet 1 of 17)
PROCEDURE INDEX
PAGE
PROCEDURE
Removal
Installation
TOOLS: 7/16 in. open end wrench
9/16 in. open end wrench
7/8 in. open end wrench
15/16 in. open end wrench
8 in. adjustable wrench
9/16 in. socket with 1/2 in. drive
5 in. extension with 1/2 in. drive
Ratchet handle with 1/2 in. drive
1/4 in. punch
1/8 in. punch
Hammer
Slip joint pliers
Torque wrench with 3/8 in. drive(0-200 lb-in)
Flat-tip screwdriver
SPECIAL TOOLS: 7/8 in. crowfoot wrench with 3/8 in. drive (Item 42, Chapter 3, Section I)
Spring pins MS39086-47 (2 required)
SUPPLIES:
Preformed packing MS28775-10
Dry cleaning solvent (Item 55, Appedix D)
Black grease pencil
Sealing compound (Item 24, Appendix D)
15 ft lacing wire (Item 61, Appendix D)
Split bushing 10915816
Two
PERSONNEL:
REFERENCE:
Block tracks to prevent vehicle movement
PRELIMINARY PROCEDURES:
Place transmission shift lever in N (neutral)
Remove powerplant (page 5-2)
Remove operator's floor access cover (page 17-17)
TA169214
Go on to Sheet 2
