TM 5-5420-226-20-3
PARKING BRAKE CONTROL ASSEMBLY AND LINKAGE REPLACEMENT (Sheet 9 of 17)
33.
When control assembly (Q) is clear of tube located behind fuel tank, the technician in the
engine compartment will disconnect wire from control assembly (Q) and remove control
assembly (Q) from vehicle. Make sure wire is secured so it will not slide out of tube.
NOTE
Step 34 applies to two piece
cable only.
34.
Using adjustable wrench, hold control assembly (Q). Using 7/8 inch wrench, loosen con-
nector (AT) on control assembly (Q). Separate control assembly (Q) into two pieces.
INSTALLATION:
NOTE
Steps 1 and 2 apply only to two piece cables.
TA169222
Go on to Sheet 10