TM 5-5420-226-20-3
PARKING BRAKE CONTROL ASSEMBLY AND LINKAGE REPLACEMENT (Sheet 5 of 17)
17.
Using 9/16 inch wrench, remove lockwasher
and screw (AA).
Using screwdriver, remove clamp (AB).
18.
NOTE
Use black grease pencil and mark
control assembly (Q) at bulkhead
wall.
19.
Using screwdriver, remove four screws (AC)
and lockwashers (AD) securing retainer (AE)
and control assembly (Q) to bulkhead.
20.
Grasp control assembly (Q) with both hands
and pull forward 1 to 2 inches. Remove split
bushing (AF). Throw bushing (AF) away.
21.
Grasp control assembly (Q) with both hands where the control assembly comes from under
subfloor and goes along bulkhead wall. Pull toward rear of launcher until control assembly
end (Q) is free from under subfloor.
Slide retainer (AE) off cable assembly (Q).
22.
Go on to Sheet 6
13-94
