TM 5-5420-226-20-3
PARKING BRAKE CONTROL ASSEMBLY AND LINKAGE REPLACEMENT (Sheet 8 of 17)
31.
Attach wire to end of control assembly
(Q) located inside compartment (com-
mander's side). Make sure that wire
is wrapped tightly several times around
end of control assembly (Q) and other
end is secured to a wrench or other
movable objet t which will not allow
the free end of wire to pass through
the bulkhead opening.
NOTE
Two technicians are required to remove control assembly (Q)
from vehicle, one technician inside compartment at com-
mander's position and one technician inside engine
compartment.
Person in engine compartment grasp control assembly (Q) with both hands and pull toward
32.
rear of vehicle, while person inside compartment feeds control assembly (Q) with wire
through bulkhead.
TA169221
Go on to Sheet 9
13-97
