TM 5-5420-226-20-3
PARKING BRAKE CONTROL ASSEMBLY AND LINKAGE REPLACEMENT (Shee 10 of 17)
Using adjustable wrench to hold control assembly (A), use 7/8 inch wrench to tighten
1.
connector (B) joining the two pieces of control assembly (A) together.
2.
Using torque wrench and 7/8 inch crow-
foot, tighten connector (B) on control
assembly (A) to 35-50 lb-in. (8.9- 12.7
Nm).
Place old and new control assemblies
3.
(A) side-by-side. Make sure that length
of end fittings match. Using black grease
pencil, mark the replacement cable
at the same location that the old (removed)
control assembly was marked.
Attach wire (C) extending from tube (D) at the engine compartment tightly to the forward
4.
end of new control assembly (A).
TA169223
Go on to Sheet 11
13-99