TM 5-5420-226-20-3
ROADWHEEL ARM REPLACEMENT (Sheet 1 of 6)
PROCEDURE INDEX
PAGE
PROCEDURE
Removal
Installation
TOOLS: Punch
Hammer
3/4 in. socket with 1/2 in. drive
Ratchet with 1/2 in. drive
Torque wrench with 1/2 in. drive (0-600 lb-ft) (0-814 Nm)
Internal puller
3/4 in. crowfoot wrench with 1/2 in. drive
3/4 in. combination box and open end wrench
Automotive wrench
Crowbar
5/8 in. socket with 1/2 in. drive
Mechanical puller adapter
Slide hammer puller
Handle
SPECIAL TOOLS: Seal inserter (Item 21, Chapter 3, Section I)
Gasket
SUPPLIES:
Seal
Grease (Item 38, Appendix D)
5/8-13 UNC threaded screws (2 required)
Lockwashers (6 required)
PERSONNEL: Three
PRELIMINARY PROCEDURES: Remove roadwheels (page 14-3)
Remove wheel hub if necessary (page 14-6).
Remove torsion bar (page 14-26).
Remove shock absorbers when removing arms at roadwheel
positions No. 1,2, and 6 (page 14-91).
Disconnect track adjusting link at No. 1 roadwheel position
Go on to Sheet 2