TM 5-5420-226-20-3
HUB AND ARM ASSEMBLY REPAIR (Sheet 8 of 9)
Coat outer edge of seal (A) with grease.
6.
7.
Position seal (A) into retainer (B) with front
of seal facing upward.
8.
Using inserter and handle, tap handle
with hammer to install seal (A).
Install special oil seal inserter to face
9.
with spacer on upper spindle of arm.
Position retainer (B) onto upper spindle.
10.
Coat inner and outer races of outboard bearings (C) with grease. Install inner race on
12.
spindle. Install outer race over it.
Go on to Sheet 9
14-22.2 Change 3