TM 5-5420-226-20-3
HUB AND ARM ASSEMBLY REPAIR (Sheet 9 of 9)
Apply grease to sleeve spacer (E) and bearing washer (F).
13.
Install sleeve spacer (E) onto spindle up against outboard bearing (C).
14.
Repeat step 12 to install inboard bearing (D).
15.
Install bearing washer (F) onto spindle up against inboard bearing (D) with stepside of washer
16.
(F) facing bearing (D).
Install key washer (G) on spindle of arm so that inside tab fits into groove.
17.
NOTE
Make sure outer tabs of key washer are pointing towards nut (H) .
18.
Screw nut (H) onto threaded end of spindle.
19.
Using spanner wrench, tighten nut (H)
until parts on spindle cannot be turned
by hand.
Back off nut (H) just enough so parts can
20.
be turned by hand through one complete
turn on spindle.
21.
Using pliers, bend tab on key washer (G)
into alining slot on nut (H).
Install roadwheel arm (page 14-17).
22.
End of Task
14-23
