TM 5-5420-226-20-3
SUSPENSION TORSION BAR REPLACEMENT (Sheet 5 of 7)
1.
Apply grease to splined ends of torsion bar (A).
2.
Fill outer end opening with grease (1/4 inch
deep).
3.
Insert unmarked end of torsion bar (A) into
roadwheel support arm (B).
Rotate torsion bar (A) so that index mark
4.
is at top.
5.
Push torsion bar (A) through support arm (B)
housing until the inside end enters the anchor
on the other side of vehicle, when this is
done about 1/2 inch of the torsion bar will
be out of the support arm (B) housing.
Go on to Sheet 6
14-30 Change 3
