TM 5-5420-227-24
OVERHEAD CYLINDER HOSE ASSEMBLIES (CL, CM, CN, AND CO) AND HYDRAULICS
REPLACEMENT (Sheet 5 of 8)
INSTALLATION:
NOTE
Remove all caps and plugs as necessary during installation. Before instal-
lation, use pipe tape on all male threads. Start tape on second thread so
tape will not enter hydrauIic system. Locate and aline parts as shown in
illustrations to make sure connecting parts mate at final assembly.
Using care to prevent damage, clamp
1.
relief valve (A) in vise.
Using 1-1/8 inch wrench, install nipple
2.
(B) into valve (A).
Holding nipple (B) with 1-1/8 inch wrench,
3.
use 12 inch adjustable wrench to install
elbow (C) on nipple (B).
Using 1-1/8 inch wrench, install adapter (D) and collar (E) on relief valve (A).
4.
Using 12 inch adjustable wrench, install elbow (F) and collar (G) into relief valve (A).
5.
6.
Remove relief valve (A) and attached parts from vise.
7.
Using 12 inch adjustable wrench, install elbow (C) and attached parts on rod end of cylinder
(H).
Holding adapter (D) with 1-1/8 inch wrench, use 1-1/4 inch wrench to install hose assembly
8.
(J) on nipple (D).
Holding elbow (F) with 12 inch adjustable wrench, use 1-1/4 inch wrench to connect
9.
hose assembly (K) to elbow (F).
Go on to Sheet 6
TA170349
3-123