TM 5-5420-227-24
SERVICING HYDRAULIC RESERVOIR FILTER ASSEMBLY (Sheet 2 of 2)
CLEANING AND INSPECTION:
WARNING
Cleaning agent specified is flammable. Use only in well ventilated areas, Keep away
from flames, sparks, or heat. Do not smoke while using. Prevent contact with eyes
mouth, and/or skin. Wear rubber gloves when performing cleaning procedures.
1.
Using rags and dry cleaning solvent,
clean all parts.
2.
Inspect filter element for damage,
cracks, or deterioration.
Replace filter element if defective
3.
INSTALLATION:
1.
Manually install new packing (A) in filter
element (B).
Manually install new packing (C) in cover
2.
(D).
Aline groove (E) of filter element (B) with
3.
tab (F) on cover (D) and press filter element
(B) on cover (D) until tab (F) snaps in place.
Insert assembled filter element (B) and
4.
cover (D) in housing (G) and aline screw
holes.
Manually install four screws (H) and new
5.
lockwashers (J).
Using socket, tighten four screws (H).
6.
Service hydraulic reservoir (LO 5-5420-226-12).
7.
Bleed hydraulic system (page 3-66).
8.
Check for hydraulic leaks and correct as necessar
9.
Service hydraulic reservoir (LO 5-5420-226-12).
10.
End of Task
3-201