'TM 5-5420-227-24' by LOGSA

TM 5-5420-227-24

Section IV. HYDRAULIC CYLINDERS

OVERHEAD CYLINDER ARMOR REPLACEMENT (Sheet 1 of 2)

9/16 in. socket with 1/2 in. drive

TOOLS:

15/16 in. socket with 1/2 in. drive

Ratchet with 1/2 in. drive

9/16 in. combination box end and open end wrench

Pry bar

Sling

Lifting device (200 lbs capacity)

SUPPLIES:

Lockwashers (2 required)

Lockwashers (4 required)

REFERENCE:

REMOVAL:

Using 9/16 inch socket on screw (A) and box

wrench on nut (B), remove two screws (A), nuts

(B), lockwashers (C), four flat washers (D),

and stop (E). Throw lockwashers (C) away.

Using 15/16 inch socket, remove four screws (F),

flat washers (G), and lockwashers (H). Throw

lockwashers (H) away.

B e careful w h e n lifting cylinder

armor. Serious injury to- p e r s o n n e l

can result from careless handling.

Attach sling to forward end of armor (J) and

attach lifting device.

Usiing prv bar, raise rear end of armor (J) en

to get hooks of sling through fastener holes

at rear end of armor.

Using lifting device, remove armor (J).

Remove sling from armor (J).

TA170440

G O on to Sheet 2

3-217