TM 5-5420-227-24
OVERHEAD CYLINDER ARMOR REPLACEMENT (Sheet 2 of 2)
INSTALLATION:
1.
Attach sling to armor (A).
2.
Using lifting device, position armor on overhead cylinder (B).
3.
Remove sling from armor (A); use pry bar to
aid removal of hooks at rear of armor.
4.
Place new lockwashers (C) and flat washers (D) on four screws (E).
5.
Using pry bar, aline holes of armor (A) with
those in overhead cylinder (B).
6.
Manually install four screws (E).
7.
Using 15/16 inch socket, tighten four screws (E).
8.
Place flat washer (F) on two screws (G).
Position stop (H) on armor (A) and insert two screws (G).
9.
10.
Place flat washers (F), new lockwashers (J), and nuts (K) on two screws (G).
11.
Using 9/16 inch socket on screw (G) and wrench on nut (K), tighten two screws.
End of Task
3-218