TM 5-5420-228-24
RESERVOIR QUADRANT BLOWER ASSEMBLY REPAIR (Sheet 2 of 2)
NOTE
Do steps 1 and 2 only if plate
(A) was removed.
ASSEMBLY:
1.
Place identification plate (A) on shroud (B).
2.
Using hammer, install four new drive screws (C).
3.
Place motor (D) in shroud (B).
4.
Using 7/16 inch socket and extension, install four screws (E) and lockwashers (F).
Place key (G) in position.
5.
6.
Place impeller (H) in position.
7.
Manually holding impeller (H) stationary, use 3/4 inch socket and extension to install
nut (J).
8.
Install blower assembly in vehicle (page 3-4).
TA251655
End of Task
4-3
