TM 5-5420-228-24
GENERAL MAINTENANCE - Continued
Removal of Studs Broken at Surface (Sheet 2 of 3)
NOTE
After being drilled, studs broken
at a surface may be removed
either by using a spiral tapered
screw extractor or a fluted type
extractor. If a spiral tapered
screw extractor is used, go to
step 6.
If a fluted type
extractor is used, go to step 9.
6.
Using tap wrench handle (C) with screw
extractor (D), turn tap wrench handle (C) slowly
counterclockwise to screw extractor (D) into
stud (B).
7.
Keep turning extractor slowly counter-
clockwise until stud (B) is removed from
threaded hole (E),
8.
Using clean rag, wipe out threaded hole (E)
and surface (F).
Go on to Sheet 3
TA251282
C-12
