TM 5-5420-228-24
GENERAL MAINTENANCE - Continued
Removal of Studs Broken at Surface (Sheet 3 of 3)
Using hammer, drive fluted extractor (G) into
9.
stud (B).
10. Manually start nut (H) counterclockwise
on extractor (G).
11. Using wrench, tighten nut (H) on extractor
(G) by turning counterclockwise.
12. Using wrench, keep turning nut (H) counter-
clockwise until stud (B) is removed from
threaded hole (E).
13. Using clean rag, wipe out threaded hole (E) and
surface (F).
TA251283
End of Task
C-13
