TM 5-5420-228-24
GENERAL MAINTENANCE - Continued
Removal of Studs Broken Below Surface (Sheet 2 of 3)
NOTE
After being drilled, studs broken
b e l o w surface may be removed
either by using a spiral tapered
screw extractor or a fluted type.
If a spiral tapered screw extractor
is used, go to step 7. If a fluted
type extractor is used, go to step
10.
7 . Using tap wrench handle (E) with screw
extractor (F), turn tap wrench handle (E)
counterclockwise to screw extractor (F) into
stud (D).
Keep turning extractor slowly counter-
8.
clockwise unit stud (D) is removed from
threaded hole (G).
Using clean rag, wipe out threaded hole (G)
9.
and surface (H).
TA251285
Go on to Sheet 3
C-15
