BAP WinchHold-FrameFront Pin LocksdownLockRearCenterTransloadFluidCONDITIONLocks1Levers2LockJaw3Latch3GuidesRollerRollersPLS FeetLinesTM 5-5420-278-100018 000018 00-2CBT PREPARATION FOR USE (Contd)1Free Bridge IN DOWN UP CLOSED N/A OUT UP STOWED STOWED ENGAGEDBay Launch2Controlled IN DOWN DOWN N/A DOWN OUT DOWN STOWED STOWED ENGAGEDBridge BayLaunch3Water BridgeIN DOWN DOWN CLOSED UP MID DOWN STOWED STOWED ENGAGEDBay Retrieval4Unload BridgeIN DOWN DOWN N/A DOWN OUT DOWN STOWED STOWED ENGAGEDBay to Ground5Load Bridge IN DOWN DOWN CLOSED UP MID DOWN STOWED STOWED ENGAGEDBay from Ground6Load BAP OUT UP UP4CLOSED4N/A MID4DOWN STOWED STOWED STOWEDfrom Ground7Unload BAPOUT UP UP4CLOSED4N/A MID4DOWN STOWED STOWED STOWEDto Ground8Transport IN UP/DOWN UP CLOSED4N/A MID5DOWN STOWED STOWED EITHERMode9Transload BAP OUT UP UP CLOSED4N/A MID5DOWN DOWN6STOWED STOWEDto Trailer10Transload BAP OUT UP UP CLOSED4N/A MID5DOWN DOWN7STOWED STOWEDto Truck11Load/unloadOUT UP UP CLOSED N/A MID DOWN DOWN DOWN STOWEDBAP on PLSTruckTable 1. BAP Locks Checklist. This table shows the various positions locks should be in for all BAP operations.1BAP hold-down locks are located on the transporter.2UP is locked on the BAP; DOWN is locked on theLHS hook arm.3Jaw and latch.4N/A for an empty BAP.5IN for an empty BAP.6Moved to UP position after the BAP is fully ontrailer.7Moved to STOWED position after the BAP is fully ontruck.END OF WORK PACKAGEc. Ensure Unit maintenance has serviced the vehicle; refer to DA Form2404/5988-E, Equipment Inspection and Maintenance Worksheet.d. Perform all operator/crew Before PMCS procedures as listed in WP 0014, table1, prior to operating the CBT.e. Review the BAP Locks Checklist, WP 0018, table 1, prior to performing BAPoperations for each condition.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business