LOCATION OF BASIC ISSUE ITEMS (BII), COMPONENTS OF END ITEMS (COEI), AND ADDITIONAL AUTHORIZATION LIST (AAL) ITEMS

Figure 1. Conventional Rafting Procedures.

Section IV. OPERATION UNDER UNUSUAL CONDITIONS

TM-5-5420-278-10 M85 Tank Chassis Transporting: for Bridge Armored-Vehicle-Launched Scissoring Type Class 80 Manual
Page Navigation
338

TM 5-5420-278-10 0044 00 0044 00-1/2 blank LOCATION OF BASIC ISSUE ITEMS (BII), COMPONENTS OF END ITEMS (COEI), AND ADDITIONAL AUTHORIZATION LIST (AAL) ITEMS a. The following items are stowed in the stowage compartments of the ramp bay: (1) Two ropes for securing bay. (2) Two hand levers for operation of pumps. (3) IRB hoisting gear (lifting sling) for high-bank launch. (4) Spare Chem-lite tubes. (5) Two coupling devices for bay-to-bay connection. (6) Roadway tool for closing gap between inner-to-inner pontons. (7) 19 mm wrench for removing drain plugs. b. The following items are stowed on the transporter: (1) T-wrench for engaging swivel hooks, outer ponton locks, lower lock-drive pins, and removal of bilge plugs. (2) Rope for bridging from centerline. (3) Pin and rope (lanyard) for releasing travel latch during controlled launch. (4) Boat hook for assisting BEB crew and opening/closing foldlocks and travel latches. (5) Rope for releasing lashing device during free launch of bay. (6) Crowbar for use with roadway tool and during bay-to-bay connection. c. The following items are stowed on the Bridge Erection Boat: (1) Rafting brackets for longitudinal rafting or docking of interior bays. END OF WORK PACKAGE

Privacy Statement
Press Release
Contact