TM 5-5420-278-24&P
0033 00
0033 00-2
PUMP ACCESS COVER REPLACEMENT (Contd)
NOTE
Removal and installation of right and left pump access covers are
the same. Right side is shown.
REMOVAL
1.
Remove three nuts (12), lockwashers (13), screws (17), washers (16), and hinge block (15) with
access cover (1) from roadway inner ponton opening (11). Discard lockwashers (13).
2.
Remove pin (14) from hinge block (15) and access cover (1).
3.
Remove two screws (4), washers (3), and metal strap (2) from access cover (1).
4.
Remove two screws (6) and spring clips (5) from access cover (1).
NOTE
Perform step 5 if instruction plate is to be removed.
5.
Remove four screws (8) and instruction plate (7) from access cover (1).
6.
Remove two screws (9) and stop plate (10) from roadway inner ponton opening (11).
INSTALLATION
1.
Install stop plate (10) on roadway inner ponton opening (11) with two screws (9).
NOTE
Perform step 2 if instruction plate was removed.
2.
Install instruction plate (7) on access cover (1) with four screws (8).
3.
Install two spring clips (5) on access cover (1) with screws (6).
4.
Install metal strap (2) on access cover (1) with two washers (3) and screws (4).
5.
Apply a light coat of grease to pin (14) and install access cover (1) on hinge block (15) with pin (14).
6.
Install hinge block (15) with access cover (1) on roadway inner ponton opening (11) with three
washers (16), screws (17), new lockwashers (13), and nuts (12).
7.
Install Chem-lite holder (TM 5-5420-278-10).
8.
Fold ramp bay and install ramp bay on transporter (TM 5-5420-278-10).
