TM 5-5420-278-24&P
0035 00
0035 00-6
PUMP MAINTENANCE (Contd)
ASSEMBLY
A. Instruction Plate, Mounting Plate, and Fill Plug
1.
Install new gasket (26), if necessary, and fill plug with dipstick (25) on pump reservoir (31).
2.
Install spacer (27) and mounting plate (28) on pump housing (32) with two washers (30)
and screws (29).
3.
Install instruction plate (17), if removed, on plate (18) with four new drive screws (14).
4.
Install plate (18) on pump housing (32) with two new lockwashers (16) and screws (15).
B. Control Lever
1.
If removed, install control block (24) on spool valve shaft (not shown) with spring pin (19).
2.
Install spring (23) and control lever (22) on control block (24) with spring pin (20).
3.
Install knob (21) on control lever (22).
C. Pump Lever
1.
Install lever support (34) on pump housing (32) with four new lockwashers (13) and screws (12).
2.
Install two straps (11) on lever support (34) with screw (35), washer (9), and nut (10).
3.
Install spacer (39) between two straps (11) with washer (36), screw (37), nut (7), and
new cotter pin (8).
4.
Install pump lever (3) between two straps (11) with screw (38), washer (5), and nut (6). Do not
overtighten nut (6); pump lever (3) must move freely after tightening nut (6).
5. Install pump lever (3) on piston rod (33) with pin (4), washer (2), and new cotter pin (1).
