TM 5-5420-278-24&P0036 000036 00-2CYLINDER REPLACEMENT (Contd)NOTERemoval and installation of cylinders are the same. Left side is shown.REMOVALWARNINGAccidental or intentional introduction of liquid contaminants intothe environment is in violation of state, federal, and militaryregulation. refer to Army POL (WP 0001 00) for informationconcerning storage, use and disposal of these liquids. Failure to doso may result in injury or deathCAUTIONCap or plug all hoses, connections, and openings immediatelyafter disconnection to prevent contamination. Remove caps orplugs prior to installation. Failure to do so may result in damageto equipment.NOTEFluid system must be bled whenever pumps, cylinders, or hosesare replaced.Tag all hoses for installation. Have container ready to catch fluid.WARNINGRelieve residual pressure on fluid system before disconnectinglines by moving control valve lever to all positions and thenplacing lever in transport/crossing position. Failure to do so mayresult in injury or death.1.Loosen nut (6) and remove tee fitting (5) with hoses attached from adapter (7) on cylinder housing (15).2.Loosen nut (12) and remove tee fitting (13) with hoses attached from adapter (11) on fluid lockassembly (8).3.Remove hose assembly (4) and O-ring (18) from adapter (17) on cylinder housing (15). Discard O-ring (18).4.Remove six screws (1), access cover (2), and rubber stop pad (3) from inner ponton (14).5.Support cylinder housing (15) and cylinder end yoke (9), and remove retainer pin (20) from cylinderend yoke (19) and inner ponton (14).NOTEAssistant will help with step 6.6.Using lifting device, strap, and assistant, remove cylinder housing (15) from opening (10) and innerponton (14).7.Remove adapter (11) from fluid lock assembly (8). 8.Remove adapter (7) from cylinder housing (15).9.Remove adapter (17) and gasket (16) from cylinder housing (15). Discard gasket (16).
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
