TM-5-5420-279-10
Tail lift Hand Control
4.17.1.7
On the tail lift pendant, press and hold the LIFT UP switch to raise the tail lift platform.
Make sure the lift hydraulic cylinders extend to raise the tail lift platform.
4.17.1.8
Release the LIFT UP switch on the tail lift pendant when the tail lift platform height is
sufficient to pass through the space between the top of the home bank ramp module
and the underside of the lower cross member of the A-frame.
4.17.1.9
In the launch vehicle cab, to the right of the driving position, on the left side of the
center console, set the 4-position mode selector rotary switch to position 3. Make
sure the PTO disengages and the engine rpm reduces to idle.
TRANSFER CASE
LOCKUP
ENGAGE ONLYWHEN CTIS/LOCKUP
SELECTION DOES NOT PROVIDE
3
2
SUFFICIENTTRACTION FOR CONDITION.
RETURNTRANSFER CASETOTHE
UNLOCKED POSITION AS SOON AS
CONDITIONS ALLOW
4
CAUTION
DO NOT ENGAGETRANSFER CASE1
LOCKUPWHILEWHEELS ARE SLIPPING
ORWHENTURNING A CORNER,
DAMAGETO DRIVELINE MAY RESULT
ROTARY SWITCH
12V DC
24V DC
EMERGENCY STOP OVERRIDE
AUX
AUX
Pos
Function
WARNING
1
Highway
Check Aux
Light Off
WHEN SET, EMERGENCY STOP
2
`A'Frame
BUTTONS ARE NOT ACTIVE
Selected in Neutral
OVERRIDE BUTTON ONLY ACTIVE
Deploy/Stow
Park Brake on
WITH ROTARY SWITCH IN POSN 2 + 4
OVERRIDE RESETSTO OFFWHEN
Slide Frame
3
XDCDC SSFGE POSN CHANGED
Extend/Retract
RESET E-STOP AT INTERFACE PANEL
AFTER PUSHINGTHIS BUTTON
Requires Transmission
4
Build
Selected in Neutral. PB on
686A660
4 Position Rotary Switch in Cab
4-103