TM-5-5420-279-10
4.17.2.6
Coil the tail lift umbilical cable and return the cable and the tail lift pendant to their
stowage position.
NOTE
At this point, the launcher can be driven off site to allow the approach ramps to be laid
and trafficking to commence. If this is to be carried out, the tail lift should be raised to
support the far bank support.
4.17.2.7
In the launch vehicle cab, to the right of the driving position, on the left side of the
center console, set the 4-position mode selector rotary switch from 2 to 1. Make sure
the PTO disengages and the engine rpm reduces to idle.
TRANSFER CASE
LOCKUP
ENGAGE ONLYWHEN CTIS/LOCKUP
SELECTION DOES NOT PROVIDE
3
2
SUFFICIENTTRACTION FOR CONDITION.
RETURNTRANSFER CASETOTHE
UNLOCKED POSITION AS SOON AS
CONDITIONS ALLOW
4
CAUTION
DO NOT ENGAGETRANSFER CASE1
LOCKUPWHILEWHEELS ARE SLIPPING
ORWHENTURNING A CORNER,
DAMAGETO DRIVELINE MAY RESULT
ROTARY SWITCH
12V DC
24V DC
EMERGENCY STOP OVERRIDE
AUX
AUX
Pos
Function
WARNING
1
Highway
Check Aux
Light Off
WHEN SET, EMERGENCY STOP
2
`A' Frame
BUTTONS ARE NOT ACTIVE
Selected in Neutral
OVERRIDE BUTTON ONLY ACTIVE
Deploy/Stow
Park Brake on
WITH ROTARY SWITCH IN POSN 2 + 4
OVERRIDE RESETSTO OFFWHEN
Slide Frame
3
XDCDC SSFGE POSN CHANGED
Extend/Retract
RESET E-STOP AT INTERFACE PANEL
AFTER PUSHINGTHIS BUTTON
Requires Transmission
4
Build
Selected in Neutral. PB on
686A660
4 Position Rotary Switch in Cab
4.17.2.8
Disengage case lock (all wheel drive).
4.17.2.9
Engage the launch vehicle transmission and release the parking brake. Drive the
launch vehicle to the staging area.
4.17.2.10 On arrival at the staging area, position the launch vehicle for A-frame recovery.
4.17.2.11 Disengage the launch vehicle transmission, apply the parking brake, and fit chocks to
the front wheels.
4-106
