TM-5-5420-279-10
4.19.1.13 Reverse launch vehicle to allow the connection of trailer LVT. Connect the launch
vehicle to the launch vehicle trailer LVT.
4.19.1.14 Remove chocks from trailer wheels and release trailer handbrake.
4.19.1.15 Engage the launch vehicle transmission and release the handbrake. Drive the launch
vehicle and trailer LVT from the staging area.
NOTE
If a second 65.5 ft (20 m) bridge is to be deployed, drive the launch vehicle and its trailer
LVT to a suitable position to continue this task.
4.19.1.16 All vehicles return to base, observe all speed limitations concerning the driving of the
launch vehicle and CBT vehicles when returning to base, refer to 4.1 Driving the
Launch Vehicle and CBT Trucks with or without Trailers Attached.
4.19.2.1
Should the no transit light on the vehicle dash come on check that both relax pins are
in, the A-frame fold micro switches are closed, at least one E-STOP button is pressed
in, the PTO manual override switch is not set and the launcher is down.
4.19.2.2
Should the no transit light come on during transit to base, stop the vehicle, apply the
parking brake, set the transmission to neutral, set the four position switch to 2.
4.19.2.3
Go to the interface enclosure and check which E-Stop is pressed in and reset it to the
out position.
4.19.2.4
Press E-STOP reset and allow the vehicle to set itself up for A-frame deployment.
4.19.2.5
Press the PARK button on the A-frame rotate sub panel of the interface enclosure.
This will lower the A-frame and extinguish the no transit light.
4.19.2.6
Press the interface enclosure E STOP button and leave it set, close the interface
enclosure and continue with the transit back to base.
