TM-5-5420-279-10
Table 8. 9 Launcher Component Lubrication (continued)
Component
Lubricant Required
Twist lock
MIL-PRF-2104 (NORMAL
If necessary.
USE)
MIL-PRF-46167 (ARCTIC
USE)
Crane
- As necessary
MIL-PRF-10924 G
lubrication points
Crane rotate gear
MIL-PRF-2105 GO-80/90
(NORMAL USE)
MIL-PRF-2105 GO-75
(ARCTIC USE)
Tail-lift
MIL-PRF-10924 G
Every 50 operating hours.
- Reservoir
MIL-PRF-2104
As per PLS vehicle manual.
- Filters
Replace
When indicated on operator
panel.
PTO drive to hydraulic pump
MIL-PRF-10924 G
Every 50 hours
WARNING
DANGER OF INJURY TO PERSONNEL WHEN WORKING NEAR ENGINE COOLING FAN,
ENGINE MUST BE TURNED OFF AND THE BATTERY ISOLATION SWITCH TURNED TO
OFF.
HYDRAULIC FLUIDS SPILLAGE. PERSONNEL MAY SLIP ON SPILT HYDRAULIC FLUID.
SUITABLE CONTAINER AND ABSORBENT MATERIAL ARE TO BE USED TO CONTAIN
SPILLAGE.
NOTE
This procedure should be read in conjunction with Chapters 4 (Bridge Build) and 5 (Bridge
Recovery) for procedures required to deploy and recover the launch vehicle, and beam
deployment.
Introduction
8.8.1.1
For instructions on changing lubricants in the following components, refer to Chapter
10 of this manual and TM 5-5420-279-23.
TM 5-5420-279-10 Chapter 10 procedure 10-24 Crane Rotate Gear.
TM 5-5420-279-10 Section 5-036 Launch Beam Drive Oil Replacement.
TM 5-5420-279-10 Section 5-039 Launch Beam Drive Brake Oil Replacement.
TM 5-5420-279-10 Section 5-042 Winch Gearbox Oil.
