TM-5-5420-279-10
Table 9. 2 Launch Frame Electrical Control Enclosure MIMIC Panel; Indicator lights
(continued)
Indicator
Light
Notes
Checks of Non Normal Status
Normal
Status
Major Fault
OFF
Indicates a MAJOR fault
LOW / LOW oil level signal (active low
with the launcher.
alarm) in alarm condition for a
continuous period more than 5
seconds.
One or more E-stop buttons have been
depressed or the E-stop relay has not
been reset (requires resetting after
vehicle ignition applied or after an E-
stop button has been depressed).
A communications fault has been
detected with one of the two interface
enclosure 8 channel output expansion
modules.
Typical reason for a communications
error would be a failure of the
respective module.
NOTE
A communications fault is briefly
indicated (2-3 seconds) on initial
power up while the controller sets
up and establishes communication
with both expansion modules (this
is normal).
The top winch cable has become slack
and the top winch tension indicator has
operated, signified by the TOP WINCH
and the FAULT light flashing. This
indication only operates when build
mode is in HIGH BANK.
Can be cleared by operating chest
pack right hand joystick rearward to re-
tension the top winch cable.
continued
9-12
