TM 5-5420-280-10
0014 00
UNLOADING PALLET TO GROUND (Contd)
WARNING
CBT will roll forward when unloading pallet to ground. All
personnel must stand clear. Failure to comply may result
in serious injury.
CAUTION
Ensure CBT is in neutral and parking brake is released to
allow transporter to roll forward when unloading pallet.
Failure to comply may result in damage to equipment.
18.
Release parking brake by pushing in PARKING BRAKE control (6) and take foot
off service brake (8).
19.
Hold joystick (5) in UNLOAD position until front end of pallet is approximately
1 ft (0.3 m) from ground, then release joystick (5).
20.
Turn HIGH IDLE switch (9) to OFF position.
21.
Hold joystick (5) in UNLOAD position until front end of pallet rests on ground.
Release joystick (5) and set parking brake by pulling out PARKING BRAKE
control (6).
CAUTION
Ensure HIGH IDLE switch is in OFF position prior to
placing vehicle transmission in gear, or damage to
transmission may result.
NOTE
If LHS hook arm does not disengage, drive CBT forward 2
in. (5 cm) and repeat step 19.
22.
Hold joystick (5) in UNLOAD position until end of LHS hook (2) is fully
disconnected from pallet hook bar (1).
23.
Push PARKING BRAKE control (6) in and drive CBT forward 5 ft (1.5 m), apply
service brake (8), move transmission selector lever (7) to N (neutral), and set
parking brake by pulling PARKING BRAKE control (6) out.
24.
Turn HIGH IDLE switch (9) to ON position.
25.
Hold joystick (5) in LOAD position until LHS hook arm (2) is fully stowed and
NO TRANSIT WHEN LIT indicator (4) is off.
26.
Turn HIGH IDLE switch (9) to OFF position.
27.
Turn PTO ENGAGE switch (10) to OFF position. PTO ENGAGE
indicator (11) should go off.
CAUTION
The LHS mode select switch must be in the 0
(OFF/TRANSPORT) position prior to road travel, or
damage to LHS main frame and hook arm cylinders may
result.
28. Turn LHS MODE SELECT switch (3) to 0 (OFF/TRANSPORT) position.
29. If pallet will be transported on ground, perform WP 0022 00.
0014 00-8