TM 5-5420-280-10
0028 00
MANUALLY LOADING PALLET FROM GROUND (Contd)
CAUTION
Ensure both steering axles are locked in the raised
position prior to loading pallet on transporter, or damage
to equipment may result.
Operating pressure range of hydraulic pump is 2,611 psi
(180 bar) to 3,408 psi (235 bar). If pressure on gage
reaches 3,626 psi (250 bar), stop and check for
obstructions, such as support wheel retaining pins
inadvertently left in place. Do not exceed 3,626 psi
(250 bar), or damage to equipment may result.
NOTE
Perform step 2 if the steering and fixed axles are in
lowered position.
2. Raise steering axles (1) and fixed axles (2) as follows:
a.
Position selector valve lever (3) in POSITION 1 or pointing left of center,
and move control valve lever (4) to position A or left of center.
b.
Install pump handle on pump lever (5), and operate hydraulic pump (6)
until steering axles (1) and fixed axles (2) are fully raised. Remove and
stow pump handle.
CAUTION
Assistant will act as ground guide when backing up CBT
and during operation of LHS. Failure to comply may
result in damage to equipment.
Prior to loading pallet from ground, ensure transload
roller bar has been removed from pallet lower support
boom or damage to equipment may result.
3. Back up CBT so that rear of vehicle is directly in line with pallet and
approximately 5 to 6 ft (1.5 to 1.8 m) away, then apply service brake (9), move
transmission selector lever (8) to N (neutral) and pull PARKING BRAKE
control (7) out.
0028 00-2