TM 5-5420-280-23&P
0107 00
ENGINE OIL FILTER REPLACEMENT (Contd)
REMOVAL
1.
Remove four forward engine mounting screws (8) and lockwashers (7) from engine support
bracket (6) and engine oil pan (5). Discard lockwashers (7).
2.
Lift engine (3) off support bracket (6) to remove oil filter (9).
NOTE
Have container ready to catch oil.
Handle, store, and dispose of drained fluids in accordance with local
policies and procedures.
3.
Turn oil filter (9) counterclockwise and remove oil filter (9) from engine (3). Discard oil filter (9).
4.
Remove mesh screen (1) from safety relief valve (2).
WARNING
Cleaning solvent mixture is combustible. Use mechanical
ventilation whenever product is used in a confined space, is heated
above ambient temperatures, or is agitated. DO NOT use or store
near heat, sparks, flame, or other ignition sources. Keep container
sealed when not in use.
Contact with cleaning solvent may cause skin irritation. Use
chemical-resistant gloves. In case of skin contact, remove any
contaminated clothing and wash skin thoroughly with soap and
water. wash contaminated clothing before reuse. Eye contact may
cause irritation, tearing, or blurring of vision. Use face shield or
goggles when eye contact may occur. In case of eye contact, flush
eyes with large amounts of water for at least fifteen (15) minutes or
until irritation subsides. Inhalation may cause irritation to upper
respiratory passages. DO NOT have food or drink in the vicinity.
Failure to comply may result in injury to personnel.
5.
Clean mesh screen (1) and filter base (4) with cleaning solvent.
INSTALLATION
NOTE
Apply a light coat of engine oil to oil filter seal at installation.
1.
Install mesh screen (1) on safety relief valve (2).
2.
Install oil filter (9) on engine (3) and tighten oil filter (9) clockwise hand tight.
3.
Lower engine (3) down onto engine support bracket (6).
4.
Align holes in support bracket (6) with holes in oil pan (5) and install four new lockwashers (7) and
screws (8).
5.
Start engine and check for oil leaks. Refer to TM 5-5420-280-10.
1
2
3
4
5
9
6
7
8
END OF WORK PACKAGE
Change 1
0107 00-2