TM 55 1945-205-24-20318 00 40318 00ASSEMBLY OF RHIB ENGINE INTAKE MANIFOLD COMPONENTSNOTENew parts must be free of burrs and distortions. New gasket must be free of loose fibers and gasket material.This procedure is typical for assembly of the leaf valves.Do not interchange parts from different assemblies.1.Position new leaf valve (14) on the leaf plate (15).a.If valve fails to properly seat, turn valve over. b.If leaf valve (14) is not closed, use a pencil eraser and apply gentle pressure.c.If leaf valve (14) still fails to close, replace.2.While holding leaf plate (15) and leaf valve (14) horizontally, install leaf stop (12). a.Install stop screws (11) in center holes and check to see that leaf valve (14) has aligned with the ports of leaf plate (15).b.If leaf valve (14) is aligned, tighten screws (11).c.If leaf stop (12) is secure, remove stop screws (11) and go to step 3.d.If leaf stop (12) is loose, remove stop screws (11) and leaf stop (12). Position a shim (13) over leaf valve (14) and go to step 3.672143515141312111089
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
