TM 55 1945-205-24-2
0318 00 5
0318 00
WARNING
3.
Apply primer and sealing compound to threads on stop screws (11) allow to air dry.
WARNING
4.
Apply primer and sealing compound to screws (11).
5.
Install leaf valve (14), leaf stop (12), shim (13) (if required), and stop screws (11) in the center of each
leaf valve (14), but do not tighten.
6.
Hold the leaf valve assembly (9) horizontally to aid in evenly positioning the leaf valve (14) over ports.
7.
Tighten stop screws (11) and proceed as follows:
a.
Check alignment of leaf valve (14) over ports by using a pencil to mark valve leaf.
b.
Using the eraser, put gentle pressure on each leaf from the intake side and view leaf valve (14) position.
{1} If leafs are positioned evenly over the ports, install remainder of stop screws (11).
{2} If not evenly positioned, loosen stop screws (11), and repeat Steps 3- 5.
8.
Using a torque wrench, evenly tighten stop screws (11) to 15 -22 in. lbs (1.7 -2.4 N-m).
WARNING
9.
Apply primer and sealing compound to screws (8) allow to air dry.
WARNING
10. Apply primer and sealing compound to screws (8).
