TM 55 1945-205-24-2
0318 00 6
0318 00
11. Position new gasket (10) on the intake manifold (7) and install each leaf plate assembly (9), using screws (8).
12. Using a torque wrench, tighten screws (8) evenly on each leaf plate assembly to 25-35 in. lbs (3-4 N-m).
INSTALL RHIB ENGINE INTAKE MANIFOLD
WARNING
1.
Apply primer and sealing compound to 16 manifold screws (6) allow to air dry.
WARNING
2.
Apply primer and sealing compound to screws (6).
3.
Position intake manifold assembly (10) on engine and install 16 screws (6). Tighten screws (6).
4.
Using a torque wrench, tighten screws (6) evenly, (in a criss-cross pattern), to 60 - 84 in. lbs (7-9 N-m).
5.
Position mounting bracket (3) on intake manifold (10).
6.
Install two screws (4) and two mounting bracket bumpers (5) Tighten screws (4).
7.
Install timing pointer (2) and screw (1). Tighten screw (1).
WARNING
8.
Clean up spilled fluid with a spill kit and dispose of spill kit waste in accordance with local procedures.
9.
Install RHIB engine carburetors. (WP 0315 00)
10. Adjust RHIB engine throttle synchronization and linkage. (WP 0271 00)
11. Install RHIB engine air silencer. (WP 0314 00)
12. Install RHIB engine cover. (WP 0297 00)
13. Install RHIB battery negative lead terminal. (WP 0336 00)
14. Perform operational check of RHIB. (TM 55-1945-205-10-2)
END OF WORK PACKAGE
