TEST FUEL PRIMER SYSTEM (cont) - TM-55-1945-205-24-2

TEST FUEL PRIMER SYSTEM (cont) - TM-55-1945-205-24-2_1020

TEST FUEL PRIMER SYSTEM (cont) - TM-55-1945-205-24-2_1022

TM-55-1945-205-24-2 Modular Causeway System (MCS) Roll-On/Roll-Off Discharge Facility Model (RRDF) RRDF-1 NSN 1945-01-473-2282 Manual
Page Navigation
873

TM 55-1945-205-24-2 0319 00 5 0319 00 c. To test each fitting, move lever to run position and observe if any fluid enters inlet fitting. No fluid should enter. d. Move lever to prime position. Fluid should come out of both inlet fittings. e. Repeat steps a through d for each inlet fitting (14) on fuel primer solenoid (10). 19. Replace defective fuel primer solenoid (10). (WP 0320 00) 20. Install fuel primer solenoid (10). a. Using terminal screw (12), connect purple wire (13) and remove tag. b. Connect three hoses (11) to solenoid inlet fittings (14). c. Position fuel primer solenoid (10) and primer solenoid bracket (9). d. Secure fuel primer solenoid (10), solenoid bracket (9) and purple grounding wire (8) using screws (6) and washers (7). Tighten screws (6) and remove tag from purple grounding wire (8). e. Install primer hose (2) on carburetor fitting (3). PRIME RUN PRIMER SOLENOID 12 6 13 10 11 11 7 8 9 14 14

Privacy Statement
Press Release
Contact