TM 55-1945-205-24-2
0322 00 4
0322 00
WARNING
2.
Remove and dispose of contaminated wiping rags in accordance with local procedures
WARNING
3.
Use clean fuel to rinse debris and dirt from the interior of all components into a drain pan.
WARNING
4.
Remove drain pan and dispose of contents in accordance with local procedures.
INSPECT RHIB ENGINE FUEL TANK HOSE AND BULB
1.
Inspect hoses (5, 7, 12) and primer bulb (17) for cracks or deterioration. Replace as necessary.
2.
Inspect the nipple and valve assemblies (14 and 15) for corrosion or clogs. Clean or replace as necessary.
ASSEMBLE RHIB ENGINE FUEL TANK HOSE AND BULB
NOTE
Repair is limited to the replacement of damaged components.
1.
Place two large band clamps (16) on ends of new primer bulb (17).
2.
Install two new nipple and valve assemblies (14 and 15) into the primer bulb (17) and secure with two large band
clamps (16). Tighten clamps (16).
NOTE
New hoses are cut to length from a 25 ft roll of 5/16 in. I.D. hose.
3.
Install new hose (12) with snap clamp (13) on nipple and valve assembly (14). Tighten snap clamp (13)
4.
Install other end of hose (12) with snap clamp (11) on fuel hose connector (1). Tighten snap clamp (11).
5.
Install new hose (5) with snap clamp (13) on nipple and valve assembly (15). Tighten snap clamp (13).