TM 55-1945-205-24-2
0064 00 2
0064 00
a.
Remove the guillotine connector bar (1).
{1} Remove bolt (2), nut (3) and friction plate (4).
{2} Pry up on the guillotine connector bar (1) using a crowbar.
WARNING
Failure to block guillotine bar in up position when removing pins and springs could
result in personal injury or death.
{3} Place a block of wood under the upper “lip” of the guillotine connector bar (1) after it is raised to hold it
in the up position.
b.
Push up on the retainer located on the underside of the male connector pins (5).
c.
Remove male connector pins (5) from the guillotine connector lock housings (6).
d.
Remove deployment springs (7).
e.
Remove guillotine connector bar (1) from guillotine lock housings (6).
5
4
7
1
6
5
7
2
3
