TM 55-1945-205-24-2
0270 00 3
0270 00
12. Remove shift control cable (16) from cable trunnion (17).
13. Remove drop pin (18) securing shift control cable (16) to shift lever (19).
14. Remove control assembly housing (14).
15. Remove throttle control cable (20) from cable trunnion (21).
16. Carefully slide throttle lever (22) out from under the plastic separator plate (23).
17. Remove drop pin (24) securing throttle control cable (20) to throttle lever (22).
18. Remove control assembly cover (15).
INSTALL RHIB THROTTLE AND SHIFT CONTROL ASSEMBLY
1.
Place new control assembly housing (14) on a flat surface.
2.
Ensure the fast idle lever (25) is flush against the control assembly housing (14).
CAUTION
Do not remove the plastic separator plate. Failure to comply could cause the control
cable drop pins to fall out and jam the control assembly.
3.
Slide the throttle lever (22) out from under the plastic separator plate (23).
WARNING
4.
Apply outboard motor grease to throttle control cable (20).
5.
Place the throttle control cable (20) eye between the halves of throttle lever (22).
WARNING
6.
Apply outboard motor grease to drop pin (24).
7.
Install drop pin (24) to secure throttle control cable (20) to throttle lever (22).
