TM 55-1945-205-24-20269 00 50269 0018. Place shift lever (19) in neutral and the neutral start switch (27) in the center of the neutral start cam (28).WARNING19. Apply a thin bead of gasket compound on the outer lips of both control assembly halves (14 and 15).CAUTIONDo not turn the cover half over. Failure to comply could cause the shift cable drop pin to fall out and jam the control assembly.20. With the control assembly cover (15) flat, place control assembly cover (14) on top.21. Press control assembly halves (14 and 15) firmly together.WARNING22. Use wiping rag to remove any excessive silicone.WARNING23. Apply outboard motor grease to three assembly screws (13).24. Install three assembly screws (13) into control assembly halves (14 and 15).25. Torque assembly screws (13) to 40 - 50 in. lb (4.5 - 5.6 N-m).26. Place throttle handle (1) on control assembly (10) in the neutral position.27. Install throttle handle screw (12).28. Torque the screw (12) to 50 - 60 in. lb (5.6 - 6.8 N-m).29. Position control assembly (10) on starboard side of the RHIB control housing (11).30. Install two control mounting screws (9) through control assembly (10) and into control housing (11).31. Install two flat washers (8), lock washers (7) and nuts (6) on mounting screws (9). Tighten nuts (6).
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
