Table 1. Lay-Out Details. - TM-55-1945-205-24-2

RIGID HULL INFLATABLE BOAT HULLRIGID HULL INFLATABLE BOAT HULL

Lay-Out Schedule Notes - TM-55-1945-205-24-2_899

TM-55-1945-205-24-2 Modular Causeway System (MCS) Roll-On/Roll-Off Discharge Facility Model (RRDF) RRDF-1 NSN 1945-01-473-2282 Manual
Page Navigation
760

TM 55-1945-205-24-2 0283 00 2 0283 00 a. Cut out the damaged area with a power jig using a fine tooth, metal blade. b. Using a grinder or disc sander, grind and sand the cutout edges to a minimum 20º included angle. c. Bevel edges back from the edge a distance equal to 12 times the laminate thickness. WARNING 2. Prepare repair patch for application. NOTE The thickness of the repair patch and components to be used depends of the portion of the hull being repaired. The following steps are typical for the application of a fiberglass patch. Table 1. Lay-Out Details. AREA NOTES LAY-OUT HULL 1 Gelcoat 1 oz. Mat 1 Unit Coremat 1 Unit 1. BEFORE COMPLETE FRACTURE HOLE TAPE 2. DAMAGED MATERIAL CUT AWAY 3. AFTER PREPARATION EDGES CUT 4. REPAIR COMPLETE SEPARATING FILM TAPE SEPARATING FILM REPLACEMENT GLASS EDGES BEVELLED (12 TIMES LAMINATE THICKNESS) BACKING PLATE (IF POSSIBLE) BACKING PLATE (IF POSSIBLE) SMALL CUT ALONG LENGTH OF FRACTURE

Privacy Statement
Press Release
Contact