TM 55-1945-205-24-2
0299 00 2
0299 00
INSTALL RHIB ELECTRICAL STARTER
WARNING
1.
Apply adhesive to the threads of mounting bolts (4 and 7).
2.
Install washers (5) on bolts (4).
3.
Install washer (8) on bolt (7).
4.
While supporting starter (6), position so mounting holes of starter (6) line up with front and back mounting
bracket holes.
5.
Install front mounting bolt (7) and washer (8) and tighten.
6.
Making sure rear mounting bracket holes align with starter (6), install two mounting bolts (4) and washers (5).
Tighten bolts (4).
7.
Using a torque wrench, tighten front mounting bolt (7) and two rear mounting bolts (4) to 168 - 192 in. lbs
(19-22 N-m).
8.
Install wire (3) and nut (1) on terminal (2) and tighten. Remove tag.
9.
Using a torque wrench, tighten nut (1) to 120 - 144 in. lbs (14 - 16 N-m).
WARNING
10. Apply neoprene coating to wire connection to seal wire (3).
11. Install RHIB engine cover. (WP 0297 00)
12. Install RHIB battery negative lead terminal. (WP 0336 00)
13. Perform operational check of RHIB. (TM 55-1945-205-10-2)
END OF WORK PACKAGE
