TM 55-1945-205-24-2
0300 00 4
0300 00
WARNING
NOTE
Do not allow dirt, dust or other debris to get into bearings or commutator of
armature assembly.
2.
Using cleaner, clean all parts to remove dirt, carbon dust and oil.
INSPECTION RHIB ELECTRICAL STARTER
1.
Inspect commutator (24) for uneven wear and pitting. Replace damaged parts.
2.
Inspect armature (13) for evidence of any damage or overheating. Replace damaged parts.
3.
Test armature (13) for grounds. Replace damaged parts.
4.
Inspect drive gear (10) and base (11) for excessive wear, damage or dirt. Replace damaged parts.
5.
Inspect drive end cap (2) for cracks. Replace damaged parts.
6.
Inspect housing (1) for cracks and ability to hold armature assembly (13) in housing. Replace damaged parts.
ASSEMBLE RHIB ELECTRICAL STARTER
WARNING
1.
Apply small amount of lubricating oil to armature bearing shaft (5).
WARNING
2.
Apply starter pinion lube to pinion helix (25).
3.
Install drive end cap (2) on armature shaft (5).
4.
Position armature assembly (13) in magnet housing assembly (1), using marks on housing (1) and
drive end cap (2) to align.
