INSTALL RHIB STARTER SOLENOID

RIGID HULL INFLATABLE BOAT ENGINE RECTIFIER/REGULATOR

TM-55-1945-205-24-2 Modular Causeway System (MCS) Roll-On/Roll-Off Discharge Facility Model (RRDF) RRDF-1 NSN 1945-01-473-2282 Manual
Page Navigation
815

TM 55-1945-205-24-2 0301 00 3/4 blank 0301 00 INSTALL RHIB STARTER SOLENOID 1. Install solenoid sleeve (20) on new solenoid (21). 2. Position solenoid mounting clamp (19) on solenoid sleeve (20). 3. Position new solenoid (21) so mounting clamp (19) holes align with mounting holes on engine. 4. Using a wire brush, clean mounting screws (18). WARNING 5. Apply adhesive to threads of mounting screws. 6. Install top and bottom mounting screws (18) through holes in mounting clamp (19) and into cylinder block. 7. Tighten mounting screws (18). 8. Install solenoid ground cable (17), washer (16) and nut (15). Tighten nut (15). 9. Install yellow/red start switch wire (14), washer (13) and nut (12). Tighten nut (12). 10. Install solenoid to starter cable (11), washer (9) and nut (8) on solenoid terminal (10). Tighten nut (8). 11. Install key switch lead (7), washer (6) and nut (5). Tighten nut (5). 12. Install red solenoid positive battery cable (4), washer (3) and nut (2). Tighten nut (2). 13. Remove all tags. WARNING 14. Coat all wire connections with neoprene coating to seal. 15. Install positive battery cable boot (1). 16. Install RHIB engine cover. (WP 0297 00) 17. Install RHIB battery negative lead terminal. (WP 0336 00) 18. Perform operational check of RHIB. (TM 55-1945-205-10-2) END OF WORK PACKAGE

Privacy Statement
Press Release
Contact