TM 55-1945-205-24-40058 00 20058 00WARNINGThis task is typical for exterior of modules. Power tools are not authorized for use when preparing modules for spot painting. Preparation procedures are in accordance with Steel Structures Painting Council, SP-2 Hand Tool Cleaning (SSPC SP-2).NOTEThe following steps will be preformed prior to module surface painting. Upon completion of rust and paint removal the substrate metal should have a faint metallic sheen and be free of oil, grease, dust, soil, salts and other contaminants.1.Remove all rust scale, mill scale, loose rust and loose paint to the degree specified by hand wire brushing, hand sanding, hand scraping, hand chipping or other hand impact tools or a combination of these methods.2.Using clean lint-free cloth, wipe area clean.PAINT COMBINATION BEACH/SEA END SECTION NON-POWERED MODULE EXTERIOR STEEL SURFACES 1.Mask off areas to be painted.WARNINGNOTEApplication temperature range limits are 40° - 120°F. No coating should be done if the surface is likely to be damaged by rain, fog, dew or dust, etc., during the drying period.2.Using brush, apply one coat of Amercoat 385 PA oxide red primer paint, Type I, Class I, Composition B in accordance with procedures contained in DOD-PRF-24648.NOTECold temperatures or high humidity will retard drying time. 3.Allow primer paint to air dry to touch, approximately 2 hours at 70°F.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business