TM 55-1945-205-24-4
0058 00 4
0058 00
3.
Back roll each coat while wet at a 90° angle to evenly spread the texture.
NOTE
Cold temperatures or high humidity will retard drying time.
4.
Allow to dry tack free, approximately 3 hours at 70°F.
WARNING
CAUTION
Do not apply anti-skid coating to air test plug ports, lift castings and shackles and
connector castings.
NOTE
Application temperature range limits are 40° - 120°F.
No coating should be done if the surface is likely to be damaged by rain, fog, dew or dust,
etc., during the drying period.
5.
Apply a second coat of anti-skid coating, after the first coat is completely tack free.
NOTE
Cold temperatures or high humidity will retard drying time.
6.
Allow anti-skid coating to dry 96 hours before heavy traffic or equipment is used on it.
PAINT COMBINATION BEACH/SEA END SECTION NON-POWERED MODULE CLEATS, D-
RINGS, GUILLOTINE CONNECTORS, RHINO HORNS, AND FLEXOR ASSEMBLIES
CAUTION
Do not prime or paint rubber surfaces of flexor assemblies.
1.
Mask off areas to be painted.
