• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
STEERING CONTROL LINKAGE ADJUSTMENT - Continued
STEERING CONTROL LINKAGE ADJUSTMENT - Continued

M48A5 Tank Chassis, Transporting: For Bridge, Armored-Vehicle-Launched; Scissoring Type, Class 60 -3 Page Navigation
  888    889    890    891    892  893  894    895    896    897    898  
img
TM 5-5420-226-20-3
STEERING CONTROL LINKAGE ADJUSTMENT (Sheet 11 of 22)
With locating pin (P) still installed, try to
52.
insert locating pin (Z). If locating pin (Z)
can be inserted, go on to step 75. If
locating pin (Z) can not be inserted, go on
to step 53.
53.
Using 9/16 inch wrench, remove screw
(AA).
54.
Move link assembly and insert locating pin
(Z).
55.
Using 9/16 inch wrench to hold steering
rod end (AB), use 9/16 inch wrench to
loosen jamnut (AC).
56.
Using 9/16 inch wrench, adjust length of control rod (AD) by turning steering rod
end (AB) clockwise or counterclockwise until screw (AA) will drop freely through
clevis (AE) and steering rod end (AB).
57.
Using small gage wire, check to see if control rod (AD) is into steering rod ends (AB)
and (AF) past witness holes. If control rod (AD) is past witness holes in both steering
rod ends (AB) and (AF), go on to step 72. If control rod (AD) is not past witness hole
in steering rod end (AB), go to step 58. If control rod (AD) is not past witness hole
in steering rod end (AF) go on to step 68.
Go on to Sheet 12
TA169401
15-41






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.