TM 5-5420-202 -20-2
ENGINE OIL COOLER FLUID PUMP CONNECTOR REPLACEMENT (Sheet 4 of 4)
Using 1-1/2 inch wrench, install hose
5.
(E) to fitting (F).
6.
Using screwdriver and 3/8 inch wrench,
install clamp (G) on hose (E) if removed
during disassembly.
7.
Position new sealing washer (H) over vent
hole.
Using 9/16 inch wrench install and tighten
8.
vent capscrew (J) through washer (H).
Using socket and torque wrench, tighten
9.
drain valve (K) to a minimum of 150 lb-
in. (17 NZm). Do not overtighten.
Perform ground hop (page 5-25). Run engine
10.
at idle until oil temperature is in normal
operating range (TM 5-5420-202-10).
Shut down engine and wait 5 minutes.
11.
Check oil level, add oil as required
12.
13.
Disconnect ground hop kit (page 5-40).
Install powerplant (page 5-14).
14.
End of Task
6-60