TM 5-5420-202-20-2
LOWER OIL FILLER TUBE AND HOSE REPLACEMENT (Sheet 1 of 2)
TOOLS: 5/16 in. socket with 1/2 in. drive
5 in. extension with 1/2 in. drive
1/2 in. open end wrench
Putty knife
Ratchet with 1/2 in. drive
SUPPLIES:
Gasket
Gloves (Item 69, Appendix D)
Drycleaning solvent (Item 55, Appendix D)
Goggles (Item 70, Appendix D)
Rags (Item 65, Appendix D)
P R E L I M I N A R Y PROCEDURE:
Remove powerplant (page 5-2)
T o prevent personal injury, wear
Dry cleaning solvent P-D-680 is toxic and flammable.
protective goggles and gloves and use only m a well-ventilated area. Avoid contact with skin,
eyes, and clothes and don't breathe vapors. Do not use near open flame or excessive heat. The
flash point for Type #1 Dry Cleaning Solvent is 100F (38C) and for Type #2 is 138F (50C).
If you become dizzy while using cleaning solvent, get fresh air immediately and get medical aid.
If contact with eyes is made, wash your eyes with water and get medical aid immediately.
REMOVAL:
NOTE
Clean all parts and general area prior to removal.
1.
Using 5/16 inch socket, loosen two clamps (A) from hose (B).
2.
Using 1/2 inch wrench, remove three screws (C) and lockwashers (D) from tube assembly
(E).
Pull tube assembly (E) and hose (B) loose and slip off two clamps (A).
3.
Using putty knife, remove gasket (F) and throw away.
4.
Go on to Sheet 2