TM 5-5420-202-20-2
ENGINE OIL FILLER CAP REPLACEMENT (Sheet 3 of 3)
INSTALLATION:
Place new gasket (A) on cap assembly
1.
(B).
Place two preformed packings (C) on
2.
cap assembly (B).
Place cap assembly (B) in position on
3.
engine access plate (D).
Using socket, install and tighten two screw
4.
(E) and washers (F).
Place engine access plate (D) in position
5.
on powerplant and push down until seated.
Using socket, install and tighten eight
6.
screws and washers (G).
7.
Place plate with electrical connectors
(H) in position.
Using socket, install and tighten four screws
8.
and washers (J).
Open filler cap (B), insert gage (K)
9.
and close filler cap (B).
10.
Install engine shroud (page 9-31).
11.
Install powerplant (page 5-14).
End of Task
6-83